Nimbus Water Systems MN-800-TF User Manual download pdf (Page 21)

§9.0 ATTACHMENTS

§9.1 REMOTE BYPASS SYSTEM INSTRUCTIONS

Indication – When water is required even though RO product water of the desired quality is not

available. This unit allows for the supply of feed water to supplement the RO water

requirement.

Installation – See the diagram below for plumbing the system. As a minimum, use tubing of at

least the RO product water outlet connection size. The feed water source for this unit should

have a valve that controls the flow rate to the storage tank when in the emergency mode of

operation.

Mount the unit on a wall convenient to the RO system and the product water storage system.

This unit is intended for use with pressurized product storage tanks.

If an atmospheric storage tank is used it must be equipped with a float actuated shutoff valve

as well as a float switch for control of the RO system. The float valve will prevent tank overflow

when in the emergency mode.

Operation – See the included instructions for TDS monitor setup and operation. If product

water TDS is found to be high, the selector valve can be used to the emergency position to

supply feed water to storage or usage while servicing the system. When the RO system

service is complete, the handle is returned to the normal position and the RO turned on.

Replacement Parts

100732 Complete TDS monitor

100886 Battery

101008 3-way ball valve

101295 Check valve

101298 Gauge

1 2 ... 16 17 18 19 20 21 22 23 24

No comments

Nimbus Water Systems MN-800-TF User Manual Page 21